Icom IC-92AD Instruction Manual - Page 93

SCAN OPERATION 10 ■ Memory scan IMPORTANT!: To perform memory scan, 2 or more memory channels MUST be programmed, otherwise the scan will not start. q Push [MR] to select memory mode. w Set the squelch level. e While pushing and holding [SCAN](2), rotate [DIAL] to select the desired scanning type. • "ALL" for full memory scan; "BAND" for band memory scan, "MODE" for mode scan, "DUP" (appears only when duplex operation is set) for duplex scan. • All memory scan selection [DIAL] FM A146 010 PSKIP µ 088 SF CM AN:ALL •AB1and4me8mo8ry s0can0selection PSKIP µ 088 2 SCAN 1 4 8 8 0 0 VFOA SCFAMN:BAND MHz A • Mode scan selection MR B PSKIP S.MW µ 088 SCFAMN:MODE •AD1upl4ex s8can8se0lect0ion SCAN:DUP PSKIP µ 088 1 r Release [SCAN](2) to start the selected scan. 2 • Scan pauses when a signal is received. 3 • Rotate [DIAL] to change the scanning direction, or resumes manually. 4 t To stop the scan, push [VFO]. 5 • During memory scan 6 FM A148 800 7 µ 012 8 9 Band memory scan function: Repeatedly scans all 10 memory channels programmed with any frequencies of the band programmed in the memory channel selected 11 for scanning. 12 Mode scan function: Repeatedly scans all memory channels in which the same operating mode as the se- 13 lected memory channel has been programmed. 14 Duplex scan function: Repeatedly scans two frequen- 15 cies (transmission/reception) during duplex scan opera- tion. 16 17 18 19 85