Netgear DG834Gv3 DG834Gv3 Reference Manual - Page 101
How to Set Up a Client-to-Gateway VPN Configuration
View all Netgear DG834Gv3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Reference Manual for the ADSL Modem Wireless Router DG834G How to Set Up a Client-to-Gateway VPN Configuration 22.23.24.25 DG834G VPN Tunnel 0.0.0.0 192.168.3.1 PCs Figure 7-3 PC (Running NETGEAR ProSafe VPN Client) Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a network gateway involves the following two steps: • "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v3" on page 7-7 uses the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway. • "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 7-12 configures the NETGEAR ProSafe VPN Client endpoint. Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v3 Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 7-2 on page 7-5. If you have special requirements not covered by these VPNC-recommended parameters, refer to "How to Set Up VPN Tunnels in Special Circumstances" on page 7-38 to set up the VPN tunnel. The worksheet below identifies the parameters used in the following procedure. A blank worksheet is at "Planning a VPN" on page 7-4. Virtual Private Networking 7-7 v1.0, January 2006