Netgear DG834Gv3 DG834Gv3 Reference Manual - Page 99

Will either endpoint use Fully Qualified Domain Names FQDNs? FQDNs supplied

Page 99 highlights

Reference Manual for the ADSL Modem Wireless Router DG834G • Will the remote end be any device on the remote LAN, a portion of the remote network (as defined by a subnet or by a range of IP addresses), or a single PC? • Will either endpoint use Fully Qualified Domain Names (FQDNs)? FQDNs supplied by Dynamic DNS providers (see "The Use of a Fully Qualified Domain Name (FQDN)" on page B-8) can allow a VPN endpoint with a dynamic IP address to initiate or respond to a tunnel request. Otherwise, the side using a dynamic IP address must always be the initiator. • What method will you use to configure your VPN tunnels? - The VPN Wizard using VPNC defaults (see Table 7-2) - The typical automated Internet Key Exchange (IKE) setup (see "Using Auto Policy to Configure VPN Tunnels" on page 7-38) - A Manual Keying setup in which you must specify each phase of the connection (see "Using Manual Policy to Configure VPN Tunnels" on page 7-48)? Table 7-2. Parameters Recommended by the VPNC and Used in the VPN Wizard Parameter Secure Association Authentication Method Encryption Method Authentication Protocol Diffie-Hellman (DH) Group Key Life IKE Life Time NETBIOS Factory Default Main Mode Pre-shared Key 3DES SHA-1 Group 2 (1024 bit) 8 hours 1 hour Enabled • What level of IPSec VPN encryption will you use? - DES - The Data Encryption Standard (DES) processes input data that is 64 bits wide, encrypting these values using a 56 bit key. Faster but less secure than 3DES. - 3DES - (Triple DES) achieves a higher level of security by encrypting the data three times using DES with three different, unrelated keys. • What level of authentication will you use? - MDS: 128 bits, faster but less secure. - SHA-1: 160 bits, slower but more secure. Virtual Private Networking 7-5 v1.0, January 2006

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190

Reference Manual for the ADSL Modem Wireless Router DG834G
Virtual Private Networking
7-5
v1.0, January 2006
Will the remote end be any device on the remote LAN, a portion of the remote network (as
defined by a subnet or by a range of IP addresses), or a single PC?
Will either endpoint use Fully Qualified Domain Names (FQDNs)? FQDNs supplied by
Dynamic DNS providers (see
“The Use of a Fully Qualified Domain Name (FQDN)” on
page B-8
) can allow a VPN endpoint with a dynamic IP address to initiate or respond to a
tunnel request. Otherwise, the side using a dynamic IP address must always be the initiator.
What method will you use to configure your VPN tunnels?
The VPN Wizard using VPNC defaults (see
Table 7-2
)
The typical automated Internet Key Exchange (IKE) setup (see
“Using Auto Policy to
Configure VPN Tunnels” on page 7-38
)
A Manual Keying setup in which you must specify each phase of the connection (see
“Using Manual Policy to Configure VPN Tunnels” on page 7-48
)?
What level of IPSec VPN encryption will you use?
DES - The Data Encryption Standard (DES) processes input data that is 64 bits wide,
encrypting these values using a 56 bit key. Faster but less secure than 3DES.
3DES - (Triple DES) achieves a higher level of security by encrypting the data three times
using DES with three different, unrelated keys.
What level of authentication will you use?
MDS: 128 bits, faster but less secure.
SHA-1: 160 bits, slower but more secure.
Table 7-2.
Parameters Recommended by the VPNC and Used in the VPN Wizard
Parameter
Factory Default
Secure Association
Main Mode
Authentication Method
Pre-shared Key
Encryption Method
3DES
Authentication Protocol
SHA-1
Diffie-Hellman (DH) Group
Group 2 (1024 bit)
Key Life
8 hours
IKE Life Time
1 hour
NETBIOS
Enabled