Netgear GS748Tv5 Software Administration Manual - Page 126

GS716Tv3, GS724Tv4, and GS748Tv5 Smart Switches MVR Interface Configuration Use the MVR Interface Configuration screen to configure the ports that belong to the MVR groups and their roles within the groups.  To configure the MVR interfaces: 1. Select Switching > MVR > Advanced > MVR Interface Configuration. 2. Select the ports to configure. For information about how to select and configure one or more ports, see Configuring Interface Settings on page 28. 3. From the Admin Mode list, select Enable to enable MVR on the selected ports. 4. From the Type list, specify the MVR type for the selected ports: • Source. The port to which the multicast traffic flows using the multicast VLAN. • Receiver. The port where a listening host is connected to the switch. It can utilize any (or no) VLAN, except the multicast VLAN. This implies that the MVR switch performs VLAN tag substitution from the multicast VLAN source port to the VLAN tag used by the receiver port. 5. (Optionally for receiver ports) From the Immediate Leave list, enable Immediate Leave mode to allow the receiver port to be removed from the multicast group membership when an IGMP leave message is received without sending an IGMP query message and waiting for the IGMP group membership report. 6. Click the Apply button. MVR Group Membership Use the MVR Configuration screen to add or remove ports from MVR groups.  To configure MVR group membership: 1. Select Switching > MVR > Advanced > MVR Group Membership. 2. From the Group IP list, select the IP address of the MVR group to configure. 3. Click the orange bar under Group IP to display the ports. 4. To add a port to the selected MVR group, click the box directly below the port number so that a check mark appears in the box. 5. Click the Apply button. Configuring Switching 126