Netgear GS748Tv5 Software Administration Manual - Page 38
IP Address, Subnet Mask, Default Gateway, Apply, Con System Information, GS716Tv3, GS724Tv4
View all Netgear GS748Tv5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
GS716Tv3, GS724Tv4, and GS748Tv5 Smart Switches 3. If you selected the Static IP Address option, configure the following network information: • IP Address. The IP address of the network interface. The factory default value is 192.168.0.239. Each part of the IP address must start with a number other than zero. For example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid. • Subnet Mask. The IP subnet mask for the interface. The factory default value is 255.255.255.0. • Default Gateway. The default gateway for the IP interface. The factory default value is 192.168.0.254. 4. Specify the VLAN ID for the management VLAN. The management VLAN is used to establish an IP connection to the switch from a workstation that is connected to a port in the same VLAN. If not specified, the active management VLAN ID is 1 (default), which allows an IP connection to be established through any port. When the management VLAN is set to a different value, an IP connection can be made only through a port that is part of the management VLAN. It is also mandatory that the port VLAN ID (PVID) of the port to be connected in that management VLAN be the same as the management VLAN ID. Note: Make sure that the VLAN to be configured as the management VLAN exists, and make sure that the PVID of at least one port that is a port of the VLAN is the same as the management VLAN ID. For information about creating VLANs and configuring the PVID for a port, see VLANs on page 87. The management VLAN has the following requirements: • Only one management VLAN can be active at a time. • When a new management VLAN is configured, connectivity through the existing management VLAN is lost. • The management station should be reconnected to the port in the new management VLAN. 5. Click the Apply button. Configure System Information 38