Panasonic AG-HPD24PJ Operating Instructions - Page 101

Changing Thumbnail Display Adding Text Memos and Shot Marks Like in main mode, you can customize the thumbnail screen to suit operating conditions and improve efficiency. (➝ "Viewing and Revising Clip Information" page 39) Text memos and shot marks can be added like in main mode. However, additions can only be made to clips on the master (L) side. ◆ NOTE: • Some menu functions do not comply with the 3D REC/PB mode. Copying Clips Selecting and Deselecting Clips Clip copying cannot be performed. Like in main mode, select clips you want to process on the thumbnail screen. (➝ "Selecting and Deselecting Clips" page 16) Clips other than Dual P2 3D clips will not be displayed as thumbnails and require main mode to be viewed properly. Playing Back Clips Playback is performed like in main mode. ◆ NOTE: • During playback and variable speed playback, the clip cannot be forwarded or rewound. Press the STILL button to engage still (SHTL 0.0) mode before performing these operations. • Text memo forward/rewind is not possible in 3D REC/PB mode. • Video and audio distortion between clips may occur when playing back clips with different video formats (1080i and 720p), or different compression formats (AVC-Intra 50 and AVC-Intra 100). Variable Speed Playback Deleting Clips You can delete clips like in main mode. Note that clips on both the master (L) side and the slave (R) side are deleted. ◆ NOTE: • Clips on a Dual P2 3D clip where the master and slave sides have been incorrectly inserted can also be deleted. • You can also delete clips on a Dual P2 3D clip where the master or slave side is missing. Take care as a Dual P2 3D clip where the master or slave side is missing cannot be played back. • A clip that spans across multiple P2 cards cannot be deleted if any of the cards is write protected. Repairing and Reconnecting Clips Repairing bad clips Clips with bad clip indicators (yellow the same way as in main mode. ) can be repaired in The master side provides variable playback like main mode. However, since the slave side will not operate at the same time, 3D video cannot be viewed. Video output during variable speed playback depends on the output signal system. • Independent right and left systems: Video is shown only on the LCD and no output is made to SDI/HDMI. However, when the SETUP - VIDEO - DISCRETE BLACK menu setting is set to OFF, the master side outputs video only via the SDI/HDMI outputs. • Side-by-side, frame packing system: Only video from the L side is output to the LCD and SDI/HDMI (video on the R side is identical to L side video). Reconnecting incomplete clips The reconnect function cannot be used in 3D REC/PB mode. ◆ NOTE: • Use main mode to reconnect incomplete clips. ◆ NOTE: • Clip seek is not performed during playback. Use seek from STILL (SHTL 0.0) status. • When the stop state is controlled by an external device, depending on the control system, video output and non-output conditions may differ. 38 3D Recording/Playback Mode (3D REC/PB): Displaying and Managing Clips