Panasonic AG-HPD24PJ Operating Instructions - Page 99
USB Device Mode
View all Panasonic AG-HPD24PJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
USB Device Mode A USB 2.0 connection with a PC allows you to use P2 cards inserted in the slots on this unit as mass storage. Note that a separate USB driver (found on the supplied CD-ROM) must also be installed on the PC. Use of P2 viewer, which can be downloaded from the following site, free of charge, allows you to manipulate clips stored on a P2 card on a Windows PC. For details on the URL (➝ "Website URL" page 2) ◆ NOTE: • For details regarding connections, refer to the Operating Instructions supplied with the PC and the application software. 1,4 ◆ NOTE: • Please refer to the operating instructions supplied with your PC and software. 4 Press the MODE button to return to regular mode. ◆ NOTE: • Recording, playback and most of other operations are not available in the USB device mode. • When using a Windows PC, install the driver using the supplied CD-ROM. 2 1 Press the MODE button when this unit is idle. 2 Select USB DEVICE in the confirmation dialog and press the SET button. "USB DEVICE" flashes on the LCD monitor to indicate that the unit is entering the USB host mode. After the mode switch, "USB DEVICE DISCONNECT" appears on the LCD monitor. This message is replaced by a "USB DEVICE CONNECT" message when the connection with the PC is completed. ◆ NOTE: • Selecting 3D REC/PB or SYNC PB mode disables mode changes until communications with the slave device are established. When an incorrect mode is selected, turn the power off and then back on again to change modes. 3 Use USB device mode operations. 36 USB Device Mode: