Panasonic AG-HPD24PJ Operating Instructions - Page 90
Connecting an External Device via the USB HOST Connector
View all Panasonic AG-HPD24PJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Main Mode FORMAT ERROR!: An unformatted P2 card is inserted. NOT SUPPORTED!: This unit does not support the inserted card. NO CARD!: No P2 card has been inserted. 3)P2 card remaining memory (or memory used)/total memory Indicates P2 card remaining free memory (or memory used)/total memory in time left in minutes. Fractions of a minute are rounded off on the display so that the sum total of the remaining memory available for recording on each P2 card may not tally with the figure for the total memory. 4)Slot remaining memory (or memory used) total The figure obtained by totaling the remaining free memory (or memory used) on the two P2 slots is shown here. Connecting an External Device via the USB HOST Connector Usable storage devices The following storage devices can be used. • Panasonic portable hard disk unit P2 store (AJ-PCS060G) • Hard disk drives or solid state drives connected via USB 2.0/3.0. ◆ NOTE: • The unit supports P2 store only in version Ver2.** or later version. P2 store hard disk in Ver1.** cannot be connected. Upgrade a hard disk using Ver1.** to the latest version before use. ◆ NOTE: • Free space of write-protected P2 cards is not included in the free space total. 5)Detailed P2 card status Select the slot of the P2 card whose status you want to check and press the SET button to view the P2 card model number and other detailed information. Press the SET or EXIT button again to close the detailed information dialog. 6)Card warning messages This warning appears when the following P2 cards are inserted. Open Detailed P2 Card Status for more information on this warning. • "RUN DOWN CARD" The maximum number of overwrites has been exceeded. • "DIR ENTRY NG" The P2 card directory structure is not supported. 4 Press the EXIT button to end processing. ◆ NOTE: • If the number of clips recorded on a P2 card exceeds the limit, "OVER MAX NUMBER CLIPS" appears in the detailed P2 card status indicating that the limit has been exceeded. Main Mode: Thumbnail Screen 27