Panasonic AG-HPD24PJ Operating Instructions - Page 123

Settings and brief function description Item XX indicates factory default settings. OUTPUT REF Select reference for video output. AUTO: Uses the reference signal input to the REF connector as reference. When there is not input to the REF connector, the selected video input signal is used as reference. When there is no reference and video input signal, the internal clock is used. REF: The reference input signal is used as reference. If there is no such signal, the internal clock is used. INPUT: The video input signal is used as reference. If there is no such signal, the internal clock is used. NOTE: • In 2D/3D mode and at frequencies other than 59.94 Hz and 50 Hz, operation is fixed at AUTO. • In 3D REC/PB mode, slave side settings are used. The master side is fixed at REF. • In SYNC PB mode, the REF setting is used. • When the input video signal is INT SG, the internal reference signal is used as a reference for input video signals. Determines whether or not to engage repeat play during playback. ON: Engages repeat play. Continues playback from the beginning when reaching the end of the last clip. OFF: Does not engage repeat play. Stops playback at the end of the last clip. REPEAT PLAY NOTE: • Repeat play is not available during TEXT MEMO playback. • If the P2 card is removed during repeat play, playback is suspended when playback reaches the clip that is no longer exists. • Even if you insert a P2 card during repeat play, additional clips are not played back until you once stop repeat play and resume it. SHUTTLE MAX Sets the maximum shuttle speed operation. X8: 8× normal speed X16: 16× normal speed X32: 32× normal speed X60: 60× normal speed X100: 100× normal speed Sets the maximum speed of FF and REW operation. X32: 32× normal speed X60: 60× normal speed X100: 100× normal speed SEEK: Seek operation to start of clip FF. REW MAX NOTE: • When SEEK is selected, FF and REW operations for FF and REW commands transferred via 9P are performed at 100x normal speed. Note that seek operations are initiated by the FF and REW commands via 9P when ORIGINAL is set in the ID OF 9P REMOTE menu. The cursor moves from left to right in thumbnail screens. • Seek (movement) is enabled in playback mode. Specifies the location where a NEXT (SHIFT + FF) and PREV (SHIFT + REW) seek operation moves to. SEEK POS SEL CLIP: The start of the clip CLIP&TEXT MEMO: The start of the clip or video text memo SYSTEM FREQ indications 59.94 Hz 50 Hz 59.94 Hz 50 Hz 23.98 Hz 24 Hz 59-23 Hz 60-24 Hz 59.94 Hz 50 Hz 23.98 Hz 24 Hz 59-23 Hz 60-24 Hz 59.94 Hz 50 Hz 23.98 Hz 24 Hz 59-23 Hz 60-24 Hz 59.94 Hz 50 Hz 23.98 Hz 24 Hz 59-23 Hz 60-24 Hz Mode 2D 3D SYNC PB (Main) MM MM M MM M MM M M 60 Setup Menu: Menu items