Panasonic AW-HE42 IP Control Specifications - Page 10

HD Integrated Camera Interface Specifications It must be borne in mind that communication with the camera is subject to some restrictions. These restrictions are as follows. 【Restrictions】 1. When using the pan-tilt head control commands, send the commands with a gap of 130 ms between each command. Given below is the sequence. PC1 (Client) ① http://192.168.0.10/cgi-bin/aw_ptz?cmd=%23 PTS4060 &res=1 Camera When sending the commands, leave a gap of at least 130 ms between each command. 200 OK "pTS4060" ② http://192.168.0.10/cgi-bin/aw_ptz?cmd=%23 PTS5050 &res=1 200 OK "pTS5050" Fig.3.1-2 Restrictions 2. The number of sessions during which the camera can be accessed simultaneously is as follows. a) Maximum number of HTTP sessions: 72 b) Number of terminals which can receive update notifications at the same time: 5 When the AW-RP50 is connected, it is counted as one unit. 3. Keep-Alive cannot be set with HTTP connections. Connect and disconnect are performed each time a command is sent or received. 4. Some settings and conditions may restrict the effects of other settings (※ including those with exclusive control conditions). See also the operating instructions which are provided with the products. 5. Send the commands which change the settings only at the point in time when the changes are required. (Do not send them at regular intervals.) ※ The applicable models incorporate an EEPROM for storing the settings, and each time a command that changes the settings is received, data is written in the EEPROM. The number of times data can be written in the EEPROM is limited so if data is sent frequently, the model will cease to operate normally when the maximum number of times for writing the data has been reached. © Panasonic Corporation 2020 All Rights Reserved. - 10 -