Panasonic AW-HE42 IP Control Specifications - Page 212

HD Integrated Camera Interface Specifications 4.1. Procedure for receiving the update notifications 4.1.1. Procedure of start/end of the update notifications reception An HTTP message is sent to the camera to start or stop the reception of the update notification from the camera. At a time like this, the number of the TCP port on the terminal for receiving the update notification (having the update notification sent) is specified. The ① update notification receive start steps and ② update notification receive end steps are each described below. ① Update notification receive start step Example) When reception is to be started with "192.168.0.10" used as the IP address of the camera http://192.168.0.10/cgi-bin/event?connect=start&my_port=31004&uid=0 ※my_port ... Number of the TCP port on the terminal (any port) Given below is the sequence which is followed when receiving the update notifications is started. 【Update notification receive start sequence】 The update notification receive start command is sent from the terminal where the update notifications are to be received. "204 No Content" is returned from the camera which has received the command. PC1 (Client) Camera http://192.168.0.10/cgi-bin/event?connect=start&my_port=31004&uid=0 204 No Content The port of PC1 where the update notifications are received is registered as port number 31004. Fig.4-1 Update notification receive start sequence 【Caution】 Proceed with the update notification receive start step when communication has been cut off because the LAN cable has been disconnected, for example. © Panasonic Corporation 2020 All Rights Reserved. - 212 -