Panasonic AW-HE42 IP Control Specifications - Page 258

HD Integrated Camera 4.4.2. Error information Interface Specifications In cases where the camera has detected error information, the error information is posted in 30-second cycles. (Error information notifications are not supported for the AK-UB300.) When operation has been restored from an error condition, [Error Code 00:Normal] is posted only once. If the error has not been detected, the error information is not posted. Given below is the information which is posted. Notification rER[Error Code] Table 4-7 Error Code In the case of the AW-HE50/AW-HE60 00h：Normal 03h：Motor Driver Error 04h：Pan Sensor Error 05h：Tilt Sensor Error 06h：Controller RX Over run Error 07h：Controller RX Framing Error 08h：Network RX Over run Error 09h：Network RX Framing Error 17h：Controller RX Command Buffer Overflow 19h：Network RX Command Buffer Overflow 21h：System Error 22h：Spec Limit Over 23h：FPGA Config Error 24h：Network communication Error 25h: Lens Initialize Error 30h:Lvds_Adjustment_NG 31h:Bar_Signal_Check_NG 32h:H_Sync_Check_NG 33h:HDMI_Check_NG In the case of the AW-HE120/AW-HE130 00h:Normal 01h:02h:03h:Motor Driver Error 04h:Pan Sensor Error 05h:Tilt Sensor Error 06h:Controller RX Over run Error 07h:Controller RX Framing Error 08h:Network RX Over run Error 09h:Network RX Framing Error 0Ah:0Bh:17h:Controller RX Command Buffer Overflow 19h:Network RX Command Buffer Overflow 21h:System Error 22h:Spec Limit Over 24h:Network communication Error 25h:CAMERA communication Error 26h:CAMERA RX Over run Error 27h:CAMERA RX Framing Error 28h:CAMERA RX Command Buffer Overflow © Panasonic Corporation 2020 All Rights Reserved. - 258 -