Samsung SHR-5162 User Manual - Page 27

System Information and Setup System Information and Setup System Information Software Version Broadcast Format Mac Address B3.07-K1.40-V2.17_0702101326 NTSC 00:00:FO:54:FF:FF USB S/W Upgrade Version 83.07-K1.40-V2.17C_0703141732 OK Cancel This setup window provides the following setting items:  Software Version: Displays the current software version. The value cannot be changed.  Broadcast Format: Displays the current broadcast format (NTSC/PAL). The value cannot be changed.  Mac Address: 6-Byte hardware address. The value cannot be changed.  USB S/W Upgrade You can update the software using a USB device. If there is no device, None is displayed. If the USB memory has an upgrade software, its version is displayed. To upgrade the software stored in the USB device, select the check box on the right and press OK. Storage Setup You can configure the storage device related settings. Storage Setup Device Information Device No ATA 1 USB Memory 1 Used/Total 295.00K/139.92G 0.00/494.98M Erase Usage Internal Backup Disk End Mode Disk End Beep OverWrite Off OK Cancel  Device Information Displays the number, capacity, and usage of ATA and USB devices. (The total capacity displayed may be lower than the actual capacity because the DVR uses some portion of it for internal purpose.) After selecting Erase for each device, you can remove the data on it. In case of USB device, you can set the usage for extension or backup. If you change the usage of the device, the stored data will be removed. SHR-5162_Eng.indb 23 05 MENU SETUP  Disk End Mode - Stop: Stops recording when the disk is full while recording is still in progress. - Overwrite: Deletes the previously recorded data to store new data when the disk is full during recording.  Disk End Beep - On: Beeps when the disk is full while recording. - Off: Although the disk is full while recording, it doesn't make beep sound.  HDD Installation Information When you click ( ), The HDD Installation Information displays on the screen. Then you can see the model name, the capacity, and the status of the HDD in your DVR. The status displays Good, Not good, and Check. In the status of Not good, you should replace the HDD. In the status of Check, you should replace the HDD or check periodically. After clicking the Alarm Setup, you can set the alarm and the duration while the status is Not good or Check. If you click the HDD location map, it displays the information about the HDD installation. When a problem occurs, you can see which HDD has a problem. The capacity of the HDD may differently appear in the Storage Setup menu and HDD Installation Information menu. HDD Installation Information No. Model 1 ST3250823ACE 2 ST3160212ACE 3 DVD RW 4 ST3250823ACE Capacity 250.05G 160.04G 250.05G Status Good Good Good Alarm Setup HDD Location Map Exit Alarm Setup NG Duration Check Duration None 10 sec None 10 sec OK Cancel HDD Location Map Exit menu setup _23 2007-06-18 11:48:14