Samsung SHR-5162 User Manual - Page 33

EVENT RECORD MODE The detailed list for event mode settings is as follows: MENU SETUP System Camera Monitoring Record Mode Event Record Schedule Backup Network Move/Control Alarm Detection Setup Motion Detection Setup Video Loss Detection Setup Select MENU Exit Alarm Detection Setup Alarm Detection Setup Sensor State Cam Alarm-Out 1 Off 1 None 2 Off 2 None 3 Off 3 None 4 Off 4 None 5 Off 5 None 6 Off 6 None 7 Off 7 None 8 Off 8 None Duration 10sec 10sec 10sec 10sec 10sec 10sec 10sec 10sec 9-16 OK Cancel  Sensor State - Off: Sensor does not operate. - N.O (Normal Open): Sensor remains open all the time. But if it gets closed, an alarm is issued. (A Contact) - N.C (Normal Close): Sensor remains closed all the time. But if it gets open, an alarm is issued. (B Contact)  Cam It is used to set a camera that synchronizes with the current sensor. The default setting follows the sensor number. A sensor can synchronize with multiple cameras so multiple values can be selected. You can set a preset for each camera to synchronize sensors with cameras. If a sensor triggers the corresponding camera, the camera can show you the preset location.  Alarm-Out It is used to set the Alarm-Out location when any alarm occurs. Currently 5 Alarm Outs are available. Select an alarm-out to synchronize with the current sensor. But multiple values can be selected.  Duration It is used to set the Alarm-Out duration. When an alarm occurs, the alarm is output for the preset time. You can select any of Off, 3sec, 5sec, 10sec, 20sec, 30sec, and Continuous. In case of SHR-5082, only 8 channels are displayed. SHR-5162_Eng.indb 29 05 MENU SETUP Motion Detection Setup You can configure the motion detection related settings. When the detection area is set, the system detects any motion in that area. Motion Detection Setup Cam M.D State Area Sensitivity Alarm-Out Duration 1 Off Set Very High None 10sec 2 Off Set Very High None 10sec 3 Off Set Very High None 10sec 4 Off Set Very High None 10sec 5 Off Set Very High None 10sec 6 Off Set Very High None 10sec 7 Off Set Very High None 10sec 8 Off Set Very High None 10sec 9-16 OK Cancel  M.D State - Off: Motion detection does not operate. - On: Motion detection is active.  Area This is used to set the motion detection area. It is not allowed to set 4 extreme rows (Up, Down, Left, Right) because the display boundary regions can vary according to the monitor specification. - Select All: Selects the whole area. - Select One: Selects a block unit for each time. - Select Quarter: Selects a quarter unit of the screen for each time. - Clear All: Clears the whole selection. - Save & Exit: Saves the setting and exits. - Exit: Exits without saving. Select All Select One Select Quarter Clear All Save & Exit Exit menu setup _29 2007-06-18 11:48:28