Samsung SHR-5162 User Manual - Page 31

05 MENU SETUP  OSG Display - Date: The date is displayed on the screen when it is set to On. - Time: The time is displayed on the screen when it is set to On. - Title: The camera name is displayed on the screen when it is set to On. - Status: Recording and event information, Audio sign, and PTZ sign are displayed on the screen when it is set to On.  Spot Out Channel This is used to monitor a specific channel by connecting a monitor to the SPOT jack on the rear of the product. When you are using two monitors, one monitor can be set for spot out monitoring. This provides two kinds of functions: Displaying the spot out channel only and auto sequencing of all channels. - Auto sequence setup ranges from Ch 1 to Ch 16. - In the auto sequence mode, channels are changed in turn. - Duration period for auto sequence is the same as the one set in Camera Setup.  Spot Out Event Monitor This is set for monitoring events from multiple channels. - Off: The event monitoring does not operate in the Spot Out channel. - 3sec, 5sec, 10sec, 20sec, and 30sec: Sets the screen duration period in the Auto Sequence mode. - Continuous: Once the event monitoring starts, the screen remains alive until you press the ALARM button.  Monitor Out Video output methods can be selected from Composite, VGA, and Dual output modes. System restarts after changing the Video output methods. - Composite video output: transfers the composite output signal. - VGA video output: transfers VGA output signal. - Dual video output: both the Composite and VGA video outputs are available to use.  PB Channel Position You can designate the playback (PB) channel location in 9-split mode. Right Down: The playback channel is displayed at the lower right side of the screen. Center: The playback channel is displayed in the center of the screen.  Multi Channel Seq. You can set the Auto Sequence interval for split screens. Available intervals are 3, 5, 10, 20, and 30 seconds. [Video Out] CAUTION You may experience low display quality while the dual video output is in use. In this case, please switch it to the composite or VGA video output. VGA video output port is not available while the composite video output is set to use and vice versa. If the MODE and ZOOM buttons are pressed and hold for 5 seconds, the system restarts while alarming beep sound. The LED blinks while restarting and the video output mode is changed. (Composite output VGA output).  VGA output: 640x480 (60Hz) RECORD MODE The detailed list for record mode settings is as follows: MENU SETUP System Camera Monitoring Record Mode Event Record Schedule Backup Network Move/Control Record Quality & Auto Deletion Record Rate & Video Size Event Record Duration Select MENU Exit Record Quality & Auto Deletion Record Quality & Auto Deletion Cam Normal 1 Level4 2 Level4 3 Level4 Event Level4 Level4 Level4 4 Level4 Level4 5 Level4 Level4 6 Level4 7 Level4 8 Level4 Level4 Level4 Level4 Auto Deletion: Off 01 Day Cam Normal 9 Level4 10 Level4 11 Level4 12 Level4 13 Level4 14 Level4 15 Level4 16 Level4 OK Event Level4 Level4 Level4 Level4 Level4 Level4 Level4 Level4 Cancel SHR-5162_Eng.indb 27 menu setup _27 2007-06-18 11:48:23