Sharp AR-BC260 ARBC260 Operation Manual - Page 24
LOADING PAPER, Loading paper in paper tray 1, Changing the paper size in paper tray 1
View all Sharp AR-BC260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
LOADING PAPER The message "ADD PAPER" or "OPEN TRAY AND ADD PAPER" will appear when paper runs out during operation. Follow the procedure below to load paper. NOTES G Do not use curled or folded paper. Doing so may cause a misfeed. G For best results use paper supplied by SHARP. (See pages 2-9, 2-17.) G When you change the paper type and size in paper tray 1, you must change the paper type and size settings as explained in "Setting the paper type" (page 2-11). G Do not place heavy objects or press hard on any tray which is pulled out. Loading paper in paper tray 1 1 Pull out paper tray 1. Gently pull the tray out until it stops. 3 Gently push tray 1 into the machine. Push the tray firmly all the way into the machine. 4 Set the paper type. If you change the paper type, be sure to set the paper type refer to "Setting the paper type" (page 2-11). 2 Load paper into the tray. Load a stack of paper no higher than the indicator line (about 500 sheets of the recommended paper for color (21 lbs. or 80 g/m2), or approximately 500 sheets of SHARP standard paper (21 lbs. or 80 g/m2)). NOTE If you load a different size of the same type of paper, you only need to change the position of the size slide (see step 2 below); you do not need to change the paper type. 5 Loading paper in paper tray 1 is now complete. Changing the paper size in paper tray 1 The following paper size settings are available for paper tray 1: 11" x 17" to 8-1/2" x 5-1/2" (A3 to A5), and "EXTRA"*1. Use the following procedure to change the size as needed. *1 This is limited to square or rectangular paper, 11" x 17" to 8-1/2" x 5-1/2" (A3 to A5) size. 1 Pull out paper tray 1. If paper remains in the tray, remove it. 2 Adjust the paper size slide to the paper size. Move the paper size slide right or left to indicate the paper size being loaded. If a special size paper is loaded in the paper tray, set the size slide to "EXTRA" to inform the machine that a special size paper has been loaded. (When AB-based size paper is loaded, move the size slide to "EXTRA".) Note that setting the size slide to "EXTRA" only informs the machine that a special size of paper has been loaded; it does not inform the machine of the specific size. If you wish to inform the machine of the specific size, follow the steps in "Setting the paper size when an extra size is loaded" (page 211). (If you do not set a size, part or all of the image may not print.) 3 Adjust the guide plates A and B by squeezing their lock levers and sliding them to the paper size to be loaded. The guide plates A and B are slidable. Adjust them to the paper size to be loaded while squeezing their lock levers. 2-2