Sharp AR-BC260 ARBC260 Operation Manual - Page 47

TROUBLESHOOTING Problem Check Solution or cause Smudges on printed Does a message appear indicating the Please contact the your dealer as soon as sheets. need for maintenance? possible. Color occur. deviations When printing in color, character and color Perform color registration as explained on pages deviations appear. 12 and 13 of the key operator's guide. The displayed paper size differs from the loaded paper size. The display of the tray's paper size slide differs from the paper size in the tray. When you change the paper size in the tray, be sure to adjust the paper size slide on the tray to the new paper size. (page 2-2) When printing on a special size of paper, part of the printed image is missing. The paper size setting is not set correctly in the paper tray settings of the custom settings. When using a special size of paper, set the correct paper size in millimeters in the paper tray settings of the custom settings (see page 2-11). If the paper size setting is not correct, part or all of the image may not print (this depends on the options installed). 2 When printing on a special size of paper using the bypass tray, part of the printed image is missing. The paper size is not set correctly in the special size settings for the bypass tray. When using a special size of paper, set the correct paper size in millimeters as explained in step 6 on page 2-12. If the paper size setting is not correct, part or all of the image may not print (this depends on the options installed). Is paper other than SHARPrecommended paper being used? Use SHARP-recommended paper. Paper curled or damp? Do not use curled or crimped paper. If you do not use paper for a long time, store paper in the wrapper in a dry location. Paper misfeeds frequently. Is the paper curled and does it frequently misfeed in the duplex module/2 x 500 sheet paper drawer or saddle stitch finisher? Paper may be curled when output depending on the paper type and quality. In some cases turning the paper over in the tray will reduce misfeeding due to curling. Multiple sheets of paper fed simultaneously? Remove the paper from the paper tray or the bypass tray, fan the paper as shown in the illustration, and then load it again. Is paper other than SHARPrecommended paper being used? Use SHARP-recommended paper. Is paper size or weight out of the allowable range? Use paper in the allowable range. Printed paper is wrinkled or the image rubs off easily. Do wrinkles appear when printing envelopes? Is the pressure adjustment lever of the fusing unit out of position? Moving the pressure adjusting levers of the fusing unit from the normal position to a weaker pressure position may help alleviate this problem. (page 2-6) Return the pressure adjusting levers of the fusing unit to the normal position. (page 2-7) Paper damp? Be sure to store paper in the wrapper in a dry location and do not store paper in a location that is Ghumid Gat a high temperature or an extremely low temperature. The contrast on the touch panel is too Is LCD contrast properly adjusted? high or too low. Adjust the contrast using "DISPLAY CONTRAST" of custom settings. (page 2-13) 2-25