Canon VIXIA HF M30 VIXIA HF M30 / HF M31 / HF M300 Instruction Manual - Page 47
Quick Start Function
View all Canon VIXIA HF M30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
2 Touch the zoom controls to operate the zoom. Touch anywhere within the Q area to zoom out or anywhere within the P area to zoom in. Touch closer to the center for a slow zoom ([Speed 1]); touch closer to the e/d icons for faster zooms ([Speed 3]). 3 Touch [a] to hide the zoom controls. NOTES • Keep at least 1 m (3.3 ft.) away from the subject. At full wide angle, you can focus on a subject as close as 1 cm (0.39 in.). • In or mode, you can also set 7/8 8 [Zoom Speed] to one of three constant speeds (3 is the fastest, 1 the slowest). • When [Zoom Speed] is set to [I Variable]: - When you use the P and Q buttons on the wireless controller, the zoom speed will be constant at [J Speed 3]. - The zoom speed will be faster in record pause mode than when actually recording, except when pre-recording (0 65) is activated. • See Specifications (0 202) for notes about this function when the recording program is set to [r Underwater] or [s Surface]. Quick Start Function When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In standby mode the camcorder consumes only about 1/3 the power used when recording, saving energy when you are using a battery pack. Additionally, when you open the LCD panel, the camcorder is ready to start recording in approximately 1 second*, allowing you to record the subject right away. * The actual time required varies depending on the shooting conditions. Operating modes: 1 With the camcorder on and in a recording mode, close the LCD panel. A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the camcorder entered standby mode. Dual Shot Mode 47