Canon XF100 XF100 / XF105 Instruction Manual - Page 89

Special Recording Modes 4 Press the START/STOP button again to stop recording. • All of the recorded frames are joined together into one clip. • The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing). 89 NOTES • You can use only one special recording mode at a time. • While recording, you cannot change the interval or number of frames. • Some frames at the point the recording was stopped may be recorded and added to the end of the clip. • Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the [J Other Functions] [Bit Rate/Resolution] or [Frame Rate] setting. • The time code advances by the number of frames recorded. If the running mode of the time code (0 70) is set to [Free Run] or the time code is input from an external source (b only), the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting. • b During special recording mode, the time code signal will not be output from the GENLOCK/TC terminal or HD/SD SDI terminal. Frame Recording Mode Set the number of frames in advance. We recommend using the wireless controller or stabilizing the camcorder, for example, on a tripod. Sound is not recorded in this mode. Configuring Frame Recording Mode 1 Open the [Rec Frames] submenu. [J Other Functions] [Frame Rec] [Rec Frames] 2 Select the desired number of frames and then press SET. • Available options are 1, 3, 6 and 9 (2, 6 and 12 if [J Other Functions] [Frame Rate] is set to [24P] or [60P]). [J Other Functions] [Frame Rec] [Rec Frames] [1] Activating Frame Recording Mode and Recording 1 Open the [Special Rec] submenu. [J Other Functions] [J Other Functions] [Special Rec] [Special Rec] 2 Select [Frame Rec] and then press SET. • [FRM STBY] appears at the top of the screen (with [FRM] flashing). [Off] 3 Press the START/STOP button to begin recording. • The camcorder automatically records the set number of frames. • The tally lamps illuminate. • [FRM STBY] changes to [N FRM REC] while recording frames and [N FRM STBY] when frames are not being recorded. • Repeat until you finish recording. 4 Open the [Special Rec] submenu. [J Other Functions] [Special Rec] 5 Select [Off] and then press SET. • Frame recording mode ends and all of the recorded frames are joined together into one clip. • The tally lamps go out and [STBY] appears at the top of the screen.