Cisco 3825 Hardware Installation Guide - Page 334

Online Insertion and Removal with a Cisco Wireless LAN Controller Module Chapter 31 Connecting Cisco Wireless LAN Controller Modules Are you sure you want to start? (y/n) y Tftp Config transfer starting. File transfer operation completed successfully. (WLAN-Controller) > Step 6 Step 7 Exit the WLAN controller module console access session by pressing Control-Shift-6, followed by x. Disconnect the WLAN controller interface connection on the router by using the disconnect command and confirming the action by pressing Enter: Router# disconnect Closing connection to 192.0.2.254 [confirm] Router# Step 8 On the router, clear the WLAN controller access session using the following command: Router# service-module wlan-controller 1/0 session clear [confirm] [OK] Router# [Resuming connection 1 to 192.0.2.254 ... ] [Connection to 192.0.2.254 closed by foreign host] Router# Step 9 Shut down the content engine interface: Router (config)# interface wlan-controller 1/0 Router (config-if)# shutdown Router (config-if)# exit Replacing the Cisco WLAN Controller Module Follow these steps to remove and replace the Cisco WLAN controller module. Step 1 Step 2 Step 3 Step 4 Step 5 Loosen the two captive screws holding the WLAN controller module in the chassis slot. Slide the WLAN controller module out of the slot. Align the replacement WLAN controller module with the guides in the chassis slot, and slide it gently into the slot. Push the module into place until you feel its edge connector mate securely with the connector on the backplane. Check that the WLAN controller module LEDs are on and that the power and enable LEDs on the front panel also are on. This inspection ensures that connections are secure and that the new unit is operational. Note Because the WLAN controller module needs to initialize itself, the EN (Enable) LED takes at least 10 seconds to come on after the PWR LED. 31-4 Cisco Network Modules Hardware Installation Guide OL-2485-20