Cisco 3825 Hardware Installation Guide - Page 58

Installing Cisco Network Modules in Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Table 2-4 Preparing Network Module Slots for Double-Wide and Extended Double-Wide Network Modules (continued) Step 4 For Double-Wide Network Modules (For double-wide network modules only) Insert 2 slot adapters on the right side of the router slot. (See the "Installing Slot Adapters" section on page 2-12.) Step 5 Install the network module. (See the "Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" section on page 2-15.) For Extended Double-Wide Network Modules Install the network module. (See the "Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" section on page 2-15.) - Installing Slot Dividers Slot dividers (see Figure 2-3) are used to customize network module slots for different Cisco network module form factors. Slot dividers are used on the following Cisco access routers: • Cisco 2851 routers • Cisco 3660 routers • Cisco 3745 routers • Cisco 3800 series Slot dividers are installed to permit use of extension voice modules (on Cisco 3800 series routers only), single-wide, and extended single-wide network modules in modular router slots. To determine whether you need to install or remove slot dividers on your Cisco access router, see Table 2-3 and Table 2-4. Figure 2-3 Slot Divider for Network Module Slots (Sample Shows Divider for Cisco 2851 and 3800 Series) 121062 To install a slot divider, perform the following steps: Step 1 Step 2 Remove any installed network modules, blank faceplates, and slot adapters from the router slot you plan to use. Insert the top rails of the slot divider between the two guide rails in the top of the network module slot. (See Figure 2-4.) 2-10 Cisco Network Modules Hardware Installation Guide OL-2485-20