Cisco 3825 Hardware Installation Guide - Page 356

Chapter 33 Connecting Cisco IP VSAT Satellite WAN Network Modules How to Install, Connect, or Replace the NM-1VSAT-GILAT Network Module Figure 33-5 Connecting the NM-1VSAT-GILAT Network Module to the ODU ODU IDU 1 2 1 LNB 2 SSPA 3 NM-1VSAT GILAT RF-IN EXT RE ON DC LOCK SYNC LINE TX 4 ODU PWR RF-OUT EN 3 RF-IN connector 4 RF-OUT connector 127469 What to Do Next Proceed to the "Connecting the NM-1VSAT-GILAT Network Module to the External Power Supply" section on page 33-12. Connecting the NM-1VSAT-GILAT Network Module to the External Power Supply This section describes how to connect the NM-1VSAT-GILAT network module to the external power supply that comes in the "Sat Kit" provided by a Gilat SkyEdge satellite service provider. The NM-1VSAT-GILAT network module requires additional power to operate the ODU, which includes the dish antenna and its parts, such as the LNB, SSPA, OMT, and feed horn. Note If an installation technician has already connected a power supply to the ODU, then do not perform this task. Instead, proceed directly to the software configuration tasks for your NM-1VSAT-GILAT network module. See the Cisco IP VSAT Satellite WAN Network Module (NM-1VSAT-GILAT) Cisco IOS feature module. 33-12 Cisco Network Modules Hardware Installation Guide OL-2485-20