Cisco 3825 Hardware Installation Guide - Page 410

How to Install, Connect, or Replace the EVM-IPVS-16A Network Module Chapter 39 Connecting Cisco Analog Video Gateway Network Modules Restrictions • Only the Cisco 3845 router supports OIR of the EVM-IPVS-16A network module. • All connections made through the EVM-IPVS-16A network module are reset during OIR. • You must perform OIR with similar modules. If you remove a network module, install another network module exactly like it in its place. Steps To perform OIR of the EVM-IPVS-16A network module in your router, follow these steps: Step 1 Step 2 Step 3 Initiate a console session with your router. Enter configuration mode and shut down the interface: Router> enable Router# configure terminal Router(config)# interface video-Service-Engine slot/0 Router(config-if)# shut Router(config-if)# shutdown Router(config-if)# exit Disconnect the terminal block connector cables from the terminal blocks on the EVM-IPVS-16A network module. Warning Hazardous voltages may be present in the outdoor camera cables under fault conditions. Disconnect all cables from the outdoor cameras before servicing this equipment. Statement 376 Step 4 Step 5 Disconnect the DB-37 to BNC video breakout cable from the VIDEO connector on the EVM-IPVS-16A network module. Using a number 1 Phillips or flat-blade screwdriver, loosen the captive mounting screws on the network module faceplate. Caution To avoid damaging the network module, always handle the network module by the handle or faceplate. Do not touch the circuit board. Step 6 Using the module handle, pull the network module from the router slot. (See Figure 39-7.) Figure 39-7 Removing a Network Module ACT 230445 ETHERNET 0 WO SERIAL EVM IPVS-16A 20 11 3210 1 39-10 Cisco Network Modules Hardware Installation Guide OL-2485-20