Cisco 3825 Hardware Installation Guide - Page 379

Chapter 35 Connecting Application Performance Assurance Enhanced Network Modules Online Insertion and Removal of NME-APA-E3 Step 9 Confirm that the NME-APA is running by using the following command: Router# service-module integrated-service-engine slot/unit status Service Module is Cisco Integrated-Service-Engine1/0 Service Module supports session via TTY line 66 Service Module is in Steady state Getting status from the Service Module, please wait. Network Module Enhanced - Application Performance Assurance 0.1.2.1 NME-APA running on BRYCE Step 10 Exit the router Telnet session: Router # exit Configuring the Replacement NME-APA Follow these steps to configure the replacement module exactly like the original. The module will not respond to Telnet commands until it has finished restarting. You must wait several minutes before performing Step 2. The exact time depends on the system configuration. Step 1 Step 2 If you have not performed the "Saving the NME-APA Configuration File" procedure on page 35-4, perform the procedure now. Telnet to the NME-APA: Router# telnet 10.10.10.2 Trying 10.10.10.2... Connected to 10.10.10.2. Escape character is '^]'. User Access Verification Username: Password: NME-APA> enable Password: NME-APA# Step 3 Step 4 Restore the network module's running configuration from the file saved in the "Saving the NME-APA Configuration File" procedure on page 35-4 by using the following command from the service module prompt: NME-APA# copy ftp://[[[username[:password]@]location]/directory]/backup.config NME-APA# copy /directory/source-file /directory/destination-file NME-APA# copy running-config startup-config Exit the network module session by using the following command: NME-APA# logout Cisco Network Modules Hardware Installation Guide 35-7