Cisco 3825 Hardware Installation Guide - Page 57

Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Installing Cisco Network Modules in Cisco Access Routers To prepare a network module slot for a single-wide or extended single-wide network module, perform the tasks listed in Table 2-3. Table 2-3 Preparing Network Module Slots for Single-Wide and Extended Single-Wide Network Modules Step 1 Step 2 Step 3 Step 4 Step 5 For Single-Wide Network Modules For Extended Single-Wide Network Modules Remove the blank faceplates from the slots you plan to Remove the blank faceplates from the slots you plan to use. (See the "Removing Blank Faceplates from Cisco use. (See the "Removing Blank Faceplates from Cisco Access Routers" section on page 2-8.) Access Routers" section on page 2-8.) Remove the slot adapters on the right side of the router Insert the slot divider. (See the "Installing Slot Dividers" slot. (See the "Removing Slot Adapters" section on section on page 2-10.) page 2-14.) Insert the slot divider. (See the "Installing Slot Dividers" section on page 2-10.) Install the network module. (See the "Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" section on page 2-15.) (For single-wide network modules only) Insert the slot - adapter on the right side of the slot you plan to use. (See the "Installing Slot Adapters" section on page 2-12.) Install the network module. (See the "Installing - Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" section on page 2-15.) Tip On Cisco 3800 series routers, extension voice modules can be installed in standard network module slots. When an extension module is installed in a standard network module slot, treat an extension voice module like a single-wide network module. To prepare a network module slot for a double-wide or extended double-wide network module, perform the tasks listed in Table 2-4. Table 2-4 Preparing Network Module Slots for Double-Wide and Extended Double-Wide Network Modules Step 1 Step 2 Step 3 For Double-Wide Network Modules For Extended Double-Wide Network Modules Remove blank faceplates from the slots you plan to use. Remove blank faceplates from the slots you plan to use. (See the "Removing Blank Faceplates from Cisco Access (See the "Removing Blank Faceplates from Cisco Access Routers" section on page 2-8.) Routers" section on page 2-8.) Remove the slot adapters on the right side of each router Remove the slot adapter on the right side of the slot. (See the "Removing Slot Adapters" section on applicable router slot. (See the "Removing Slot page 2-14.) Adapters" section on page 2-14.) Timesaver If the slot adapter is already installed against the right side wall of the router chassis, skip this step. Remove the slot divider. (See the "Removing Slot Dividers" section on page 2-12.) Remove the slot divider. (See the "Removing Slot Dividers" section on page 2-12.) OL-2485-20 Cisco Network Modules Hardware Installation Guide 2-9