Cisco 3825 Hardware Installation Guide - Page 389

Chapter 36 Connecting WAAS Enhanced Network Modules Online Insertion and Removal of Cisco Network Modules Procedure Step 7 Step 8 Step 9 Step 10 Unplug all network interface cables from the network module. Loosen the two captive screws holding the network module in the chassis slot. Slide the network module out of the slot. Align the replacement network module with the guides in the chassis slot, and slide it gently into the slot. Note If the router is not fully configured with network modules, make sure that blank panels fill the unoccupied chassis slots to provide proper airflow. Step 11 Step 12 Step 13 Step 14 Push the module into place until you feel its edge connector mate securely with the connector on the backplane. Reconnect the network interface cables previously removed in Step 7. Check that the network module LEDs are on and that the power (PWR) and enable (EN) LEDs on the front panel are also on. This inspection ensures that connections are secure and that the new unit is operational. Initiate a network module session with the following command: Router# service-module integrated-service-engine slot/unit session Trying 10.10.10.1, 2129 ... Open ISE-network module now available Press RETURN to get started! Router> enable Router# Step 15 Restore the network module running configuration by using the following command from the service module prompt: Router# copy tftp running-config tftp-server-address filename Step 16 Step 17 Exit the network module session by pressing Control-Shift-6, followed by x. On the router, clear the network module session by using the following command: Router# service-module integrated-service-engine slot/unit session clear OL-2485-20 Cisco Network Modules Hardware Installation Guide 36-7