Cisco 3825 Hardware Installation Guide - Page 54

Installing Cisco Network Modules in Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Summary of Installation Tasks When installing a network module in a Cisco access router, perform the following tasks: Table 2-1 Network Module Hardware Installation Tasks for Cisco Access Routers Step 1 Step 2 Step 3 Step 4 Step 5 For Cisco 2600 Series, Cisco 2811, Cisco 3600 Series (Except Cisco 3660 Routers), and Cisco MWR 1941-DC Routers For Cisco 2821, Cisco 2851, Cisco 3700 Series, Cisco 3800 Series, and Cisco 3660 Routers Turn off power to the router. Turn off power to the router. Remove blank faceplates from the slots you plan to use. Remove blank faceplates from the slots you plan to use. (See the "Removing Blank Faceplates from Cisco Access (See the "Removing Blank Faceplates from Cisco Access Routers" section on page 2-8.) Routers" section on page 2-8.) Install the network module. (See the "Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" and "Installing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers" sections.) Prepare the slot for the network module form factor you are installing. (See the "Preparing Cisco Router Slots for Network Module Installation" section on page 2-8.) Install blank faceplates where appropriate. (See the "Installing Blank Faceplates on Cisco Access Routers" section on page 2-7.) Install the network module. (See the "Installing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules in Cisco Access Routers" section on page 2-15 and "Installing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers" section on page 2-16 sections.) - Install blank faceplates where appropriate. (See the "Installing Blank Faceplates on Cisco Access Routers" section on page 2-7.) Installing and Removing Blank Faceplates All empty chassis slots for network modules, extension voice modules, or interface cards must be covered with blank faceplates to ensure proper cooling airflow and to prevent electromagnetic interference. Note Blank network module faceplates are for single-wide network module slots only. To install a blank faceplate over a network module slot set up for an extended single-wide, double-wide, or extended double-wide network module, you must prepare the slot for single-wide network modules. See Table 2-3 and Table 2-4 for information on preparing network module slots for different network module form factors. Cisco Network Modules Hardware Installation Guide 2-6 OL-2485-20