Cisco 3825 Hardware Installation Guide - Page 55

Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Installing Cisco Network Modules in Cisco Access Routers Table 2-2 Preparing to Install Blank Network Module Faceplates on Cisco Access Router Network Module Slots Step 1 Step 2 Step 3 On an Extended Single-Wide Slot On a Double-Wide Slot On an Extended Double-Wide Slot Install a slot adapter on the right side Install a slot divider in the slot. (See Install a slot divider in the slot. (See of the slot. (See the "Installing Slot the "Installing Slot Dividers" section the "Installing Slot Dividers" section Adapters" section on page 2-12.) on page 2-10.) on page 2-10.) Install the blank faceplate. (See the "Installing Blank Faceplates on Cisco Access Routers" section on page 2-7.) Install a slot adapter in the right side of the left slot. (See the "Installing Slot Adapters" section on page 2-12.) Install slot adapters in the right sides of both slots. (See the "Installing Slot Adapters" section on page 2-12.) - Install one blank faceplate over each Install one blank faceplate over each slot. (See the "Installing Blank slot. (See the "Installing Blank Faceplates on Cisco Access Routers" Faceplates on Cisco Access Routers" section on page 2-7.) section on page 2-7.) Installing Blank Faceplates on Cisco Access Routers To install a blank faceplate, perform the following steps: Step 1 Determine which type of blank network module faceplate you are using. (See Figure 2-1 and Figure 2-2.) Figure 2-1 Blank Network Module Panel with Screws 1 1 H6552 1 Captive screws for securing blank faceplate Figure 2-2 Blank Network Module Panel with Tabs 1 2 88397 1 Snap-lock tab (use screwdriver to remove) 2 Tab OL-2485-20 Cisco Network Modules Hardware Installation Guide 2-7