Cisco 3825 Hardware Installation Guide - Page 60

Installing Cisco Network Modules in Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Step 5 Proceed with hardware configuration tasks as listed in Table 2-3 and Table 2-4. Removing Slot Dividers Slot dividers are removed to permit use of double-wide and extended double-wide network modules in modular router slots. To determine whether you need to install or remove slot dividers on your Cisco access router, see Table 2-3 and Table 2-4. To remove slot dividers from network module slots, perform the following steps: Step 1 Step 2 Step 3 Step 4 Remove any installed network modules, blank faceplates, and slot adapters from the router slot you plan to use. Loosen the retention screw on the front of the slot divider. Pull the slot divider straight out of the network module slot. Proceed with hardware configuration tasks as listed in Table 2-3 and Table 2-4. Installing Slot Adapters Slot adapters (see Figure 2-7) are used to customize network module slots for different Cisco network module form factors. Slot adapters are used on the following Cisco access routers: • Cisco 2821 • Cisco 2851 • Cisco 3800 series Slot adapters permit installation of extension voice modules (on Cisco 3800 series routers only), single-wide, and extended single-wide network modules in modular router slots. To determine whether you need to install or remove slot adapters on your Cisco access router, see Table 2-3 and Table 2-4. 2-12 Cisco Network Modules Hardware Installation Guide OL-2485-20