Cisco 3825 Hardware Installation Guide - Page 66

Removing or Replacing Cisco Network Modules for Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Step 7 Push the ejector levers so they make contact with the network module faceplate to finish seating the network module and lock the network module into place in the router slot. (See Figure 2-13.) Figure 2-13 Seating a Double-Wide or Extended Double-Wide Network Module 121471 T D M 0 S L O T 2 S L O T 0 S L O A= S= ASCPETED GE 0/1 AAG==EFLIDN0X/K0 T 3 A F S S L A L O T F 1 S L PVDM2 PVDM1 PVDM0 AIM1 AIM0 Step 8 Proceed with connecting the network module to the network and power up the router. Tip See the "Where to Go Next" section on page 2-27 for information on locating additional hardware documentation. Removing or Replacing Cisco Network Modules for Cisco Access Routers This section describes removal and replacement procedures for Cisco network modules used in Cisco access routers, and contains the following subsections: • Removing or Replacing Single-Wide, Extended Single-Wide, and Extension Voice Network Modules from Cisco Access Routers • Removing or Replacing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers • Replacing Network Modules in Cisco Access Routers with Online Insertion and Removal Support • Removing or Replacing Application and Service Network Modules 2-18 Cisco Network Modules Hardware Installation Guide OL-2485-20