Cisco 3825 Hardware Installation Guide - Page 62

Installing Cisco Network Modules in Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Figure 2-9 Slot Adapter Locations for Double-Wide Network Modules (Generic Router) 121388 12 1 Slot adapter 2 Slot adapter Step 3 Step 4 Install other hardware if necessary. (See Table 2-3 and Table 2-4.) Orient the slot adapter so the tab on the rear of the slot adapter aligns with the slot on the router backplane. Note When correctly aligned, the captive screw on the slot adapter aligns with a threaded hole in the chassis, slot divider, or adjacent slot adapter, depending on your current hardware setup. Step 5 Step 6 Slide the slot adapter into the slot. Using a number 1 Phillips or small flat-head screwdriver, tighten the captive screw to secure the slot adapter. Tip The slot adapter can be secured to the router chassis, to a slot divider, or to another slot adapter, depending on its installation location. See Figure 2-8 for possible variations. Step 7 Proceed with hardware configuration tasks as listed in Table 2-3 and Table 2-4. Removing Slot Adapters Slot adapters are removed to permit use of double-wide and extended double-wide network modules in modular router slots. To determine whether you need to install or remove slot adapters on your Cisco access router, see Table 2-3 and Table 2-4. 2-14 Cisco Network Modules Hardware Installation Guide OL-2485-20