D-Link DGS-3612G Product Manual - Page 132

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Figure 3- 31. IGMP Snooping Settings - Edit window The following parameters may be viewed or modified: Parameter Description VLAN ID This is the VLAN ID that, along with the VLAN Name, identifies the VLAN for which to modify the IGMP Snooping Settings. VLAN Name This is the VLAN Name that, along with the VLAN ID, identifies the VLAN for which to modify the IGMP Snooping Settings. Query Interval (165535) The Query Interval field is used to set the time (in seconds) between transmitting IGMP queries. Entries between 1 and 65535 seconds are allowed. The default is 125. Max Response Time (1-25 sec) This determines the maximum amount of time in seconds allowed before sending an IGMP response report. The Max Response Time field allows an entry between 1 and 25 (seconds). The default is 10. Robustness Variable (1-255) Adjust this variable according to expected packet loss. If packet loss on the VLAN is expected to be high, the Robustness Variable should be increased to accommodate increased packet loss. This entry field allows an entry of 1 to 255. The default is 2. Last Member Query This field specifies the maximum amount of time between group-specific query messages, Interval (1-25 sec) including those sent in response to leave group messages. The default is 1. Version (1-3) Configure the IGMP version of the query packet which will be sent by the router. Host Timeout (116711450 sec) This is the maximum amount of time in seconds allowed for a host to continue membership in a multicast group without the Switch receiving a host membership report. The default is 116