D-Link DGS-3612G Product Manual - Page 330

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Select Deny to specify that packets that do not match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set. Access ID (1-128) Type in a unique identifier number for this access. This value can be set from 1 to 128. Auto Assign - Ticking this check box will instruct the Switch to automatically assign an Access ID for the rule being created. Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content, IPv6 address. Ethernet instructs the Switch to examine the layer 2 part of each packet header. IP instructs the Switch to examine the IP address in each frame's header. Packet Content Mask instructs the Switch to examine the packet header. IPv6 instructs the Switch to examine the IPv6 address in each frame's header. Priority (0-7) This parameter is specified to re-write the 802.1p default priority previously set in the Switch, which is used to determine the CoS queue to which packets are forwarded. Once this field is specified, packets accepted by the Switch that match this priority are forwarded to the CoS queue specified previously by the user. Replace priority − Tick the corresponding check box to re-write the 802.1p default priority of a packet to the value entered in the Priority field, which meets the criteria specified previously in this command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming 802.1p user priority re-written to its original value before being forwarded by the Switch. For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS section of this manual. Replace DSCP (0- This feature allows the user to specify a value to be written to the DSCP field of an incoming 63) packet. This value will over-write the value in the DSCP field of the packet. Enter a value between 0-63. Group ID (1-4) This field displays the mirror group's identity. VLAN Name Allows the entry of a name for a previously configured VLAN. Source MAC Source MAC Address - Enter a MAC Address for the source MAC address. Destination MAC Destination MAC Address - Enter a MAC Address mask for the destination MAC address. 802.1p (0-7) Enter a value from 0 to 7 to specify that the access profile will apply only to packets with this 802.1p priority value. Ethernet Type (0FFFF) Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters and numbers ranging from a-f and from 0-9. Port RX Rate (1-156249) Time Range The Access Rule may be configured on a per-port basis by entering the port number of the switch in the switch stack into this field. When a range of ports is to be configured, the Auto Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be presented with an error message and the access rule will not be configured. The beginning and end of the port list range are separated by a dash. For example, 3 specifies port 3. 2 - 4 specifies the range of ports from 2 to 4. Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress rate is 640kbit/sec.) The user many select a value between 1 and 156249 or No Limit. The default setting is No Limit. Tick the check box and enter the name of the Time Range settings that has been previously 314