D-Link DGS-3612G Product Manual - Page 338

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Figure 6- 19. Access Rule Configuration window (IPv6) To set the Access Rule for the IPv6, adjust the following parameters and click Apply. Parameter Description Profile ID This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set. Access ID (1-128) Type in a unique identifier number for this access rule. This value can be set from 1 to 128. • Auto Assign - Ticking this check box will instruct the Switch to automatically assign an Access ID for the rule being created. Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content, or IPv6 address. • Ethernet instructs the Switch to examine the layer 2 part of each packet header. • IP instructs the Switch to examine the IP address in each frame's header. • Packet Content Mask instructs the Switch to examine the packet header. • IPv6 instructs the Switch to examine the IPv6 address in each frame's header. Priority (0-7) This parameter is specified to re-write the 802.1p default priority previously set in the Switch, which is used to determine the CoS queue to which packets are forwarded to. Once this field is specified, packets accepted by the Switch that match this priority are forwarded to the CoS queue specified previously by the user. replace priority − Tick the corresponding check box to re-write the 802.1p default priority of a packet to the value entered in the Priority field, which meets the criteria specified previously in this 322