D-Link DGS-3612G Product Manual - Page 465
Trace Route, Trace Route IPv4 Route
UPC - 790069296390
View all D-Link DGS-3612G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 465 highlights
Trace Route xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch The following window will aid the user in back tracing the route taken by a packet before arriving at the Switch. When initiated, the Trace Route program will display the IP addresses of the previous hops a packet takes from the Target IP Address entered in the window, until it reaches the Switch. Trace Route IPv4 Route To view this window, click Monitoring > Trace Route > Trace IPv4 Route, as shown below: Figure 8- 36. Trace IPv4 Route window To trace the route of a packet, set the following parameters located in this window, and click Start. Parameter Description Target IP Address Enter the IP address of the computer to be traced. Domain Name Enter the domain name of the host. TTL (1-60) The time to live value of the trace route request. This is the maximum number of routers the traceroute command will cross while seeking the network path between two devices. Port (30000-64900) The virtual port number. The port number must be above 1024.The value range is from 30000 to 64900. Timeout (1-65535) Defines the time-out period while waiting for a response from the remote device. The user may choose an entry between 1 and 65535 seconds. Probe (1-9) The probe value is the number of times the Switch will send probe packets to the next hop on the intended traceroute path. The default is 1. 449