D-Link DGS-3612G Product Manual - Page 388

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch WAC Global State Toggle the State field to either Enabled or Disabled for the Web-based Access Control settings of the Switch. WAC Settings Method Redirection Path Virtual IP Virtual IPv6 HTTP(S) Port (165535) RADIUS Authorization Local Authorization Use the pull-down menu to choose the authenticator for Web-based Access Control. The user may choose: Local - Choose this parameter to use the local authentication method of the Switch as the authenticating method for users trying to access the network via the switch. This is, in fact, the username and password to access the Switch configured using the User Account Creation screen seen below. RADIUS - Choose this parameter to use a remote RADIUS server as the authenticating method for users trying to access the network via the switch. This RADIUS server must have already been pre-assigned by the administrator using the RADIUS Server window located in the 802.1X section. Enter the URL of the website that authenticated users placed in the VLAN are directed to once authenticated. This path must be entered into this field before the Web-based Access Control can be enabled. Enter a virtual IP address so that the TCP packets sent to the virtual IP will get a reply. If the virtual IP is enabled, the TCP packets sent to the virtual IP or physical IPIF's IP address will both get a reply. When the virtual IP is set to 0.0.0.0 the function will be disabled. To ensure that this function works correctly, the virtual IP address must not be configurable, that is, it cannot be an IP address that exists on the subnet. Enter a virtual IPv6 address so that the TCP packets sent to the virtual IP for IPv6 will get a reply. If the virtual IP for IPv6 is enabled, the TCP packets sent to the virtual IP or physical IPIF's IPv6 address will both get a reply. When the virtual IPv6 is set to "::", the function will be disabled. To ensure that this function works correctly, the virtual IPv6 address must not be configured to be an IPv6 address that exists on the subnet. Specify the ports to be enabled as Web-based Access Control ports. Only these ports will accept authentication parameters from the user wishing limited access rights through the Switch. When one client on a port has been authenticated for Web-based Access Control, all clients on this port are authenticated as well. WAC Authorization Network Settings Enable or disable RADIUS authorization. Enable or disable local authorization. Click Apply to implement changes made. WAC Port Settings To view this window, click Security > Web-based Access Control (WAC) > WAC Port Settings, as shown below: 372