D-Link DGS-3612G Product Manual - Page 287

Parameter xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Description IP Address Subnet Mask Interface Enter the IP address of the device to be added as a Candidate RP. Enter the corresponding subnet mask of the device to be added as a Candidate RP. Enter the IP interface where this device is located. Click Apply to add the device as a Candidate RP. PIM Static RP Settings The following window will display the parameters for the switch to become a static RP. To view this window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM Static RP Settings, as shown below: Figure 4- 131. PIM Static RP Settings window The following fields can be viewed or set: Parameter Description Group Address Enter the multicast group address for this Static RP. This address must be a class D address. Group Mask Enter the mask for the multicast group address stated above. RP Address Enter the IP address of the rendezvous Point. Click Apply to implement changes made. To remove an entry from the table, click its corresponding under the Delete heading. PIM Register Checksum Settings This window is used to configure RP addresses. The data part is included when calculating the checksum for a PIM register message to the RP on the first hop router. To view this window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM Register Checksum Settings, as shown below: Figure 4- 132. PIM Register Checksum Settings window The following fields can be set: 271