D-Link DGS-3612G Product Manual - Page 335

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Figure 6- 16. Access Rule Configuration window (Packet Content Mask) To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply. Parameter Description Profile ID This is the identifier number for this profile set. Mode Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be set. Access ID (1-128) Type in a unique identifier number for this access. This value can be set from 1 to 128. Auto Assign - Ticking this check box will instruct the Switch to automatically assign an Access ID for the rule being created. Type Selected profile based on Ethernet (MAC Address), IP address, Packet Content Mask or IPv6. Ethernet instructs the Switch to examine the layer 2 part of each packet header. IP instructs the Switch to examine the IP address in each frame's header. Packet Content Mask instructs the Switch to examine the packet header. IPv6 instructs the Switch to examine the IPv6 part of each packet header. 319