D-Link DGS-3612G Product Manual - Page 451

xStack® DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch Port Access Control The following windows are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the Port Access Control windows, click monitoring > Port Access Control. There are six windows to monitor. NOTE: The Authenticator State cannot be viewed on the Switch unless 802.1X is enabled by port or by MAC address. To enable 802.1X, go to the DGS-3600 Web Management Tool window. Authenticator State The following section describes the 802.1X Status on the Switch. This window displays the Authenticator State for individual ports on a selected device. To view the Authenticator State click Monitoring > Port Access Control > Authenticator State, as shown below: Figure 8- 24. 802.1X Authenticator State Table Settings window The information on this window is described as follows: Parameter Description Port List Enter the port or ports for monitoring information to be displayed, or tick the All Ports check box. Auth PAE State The Authenticator PAE State value can be: Initialize, Disconnected, Connecting, Authenticating, Authenticated, Aborting, Held, Force_Auth, Force_Unauth, or N/A. N/A (Not Available) indicates that the port's authenticator capability is disabled. Backend State The Backend Authentication State can be Request, Response, Success, Fail, Timeout, Idle, Initialize, or N/A. N/A (Not Available) indicates that the port's authenticator capability is disabled. Port Status Controlled Port Status can be Authorized, Unauthorized, or N/A. 435