D-Link DXS-3600-32S CLI Guide - Page 190

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide ftp: Specifies that the startup configuration file will be uploaded to the FTP server. // Specifies the upload configuration file URL on the FTP server. For example, '// username:password@locati user:[email protected]:80/config.cfg'. on:tcpport/filename vrf VRFNAME Specifies to use VPN routing and forwarding. The VRF name can be up to 12 characters long. Default Command Mode Command Default Level Usage Guideline None. Privileged Mode. Level: 15 The command can be used for: • Saving the current running configuration and setting it as the boot-up configuration file. If the boot-up configuration file exists, the boot-up configuration file will be replaced by the current running configuration file or else the current configuration file will be saved as 'config.cfg' and be configured to the boot-up configuration file. • Saving the current running configuration to the NVRAM of device. • Uploading the current running configuration to the TFTP server. • Upload the boot-up configuration to the RCP server. • Uploading the current running configuration to the FTP server. Example This example shows how to execute the boot-up configuration immediately by using the increment method. DXS-3600-32S#copy bootup-config running-config Destination filename running-config? [y/n]: y Executing boot-up configuration ...... Executing done DXS-3600-32S# Example This example shows how to save the boot-up configuration, as 'config.cfg', to the NVRAM of the device. DXS-3600-32S#copy bootup-config flash: config.cfg Destination filename [config.cfg]? y Please wait, programming flash Done. DXS-3600-32S# Example This example shows how to upload the boot-up configuration, as 'config.cfg', to the TFTP server. DXS-3600-32S#copy bootup-config tftp: Address of remote host []? 10.0.0.66 Destination filename []? config.cfg Accessing tftp://10.0.0.66/config.cfg... Transmission start... Transmission finished, file length 45421 bytes. DXS-3600-32S# 182