D-Link DXS-3600-32S CLI Guide - Page 523

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Default Command Mode Command Default Level Usage Guideline By default, no route redistribution to RIP is configured. The default value of the metric is 0. By default, no route map is configured. Router Configuration Mode. Router Address Family Configuration Mode. Level: 8. (EI Mode Only Command) This command is used to add route redistribution from other routing protocols into RIP on the switch. Changing or disabling any keyword will not affect the state of other key-words. It is not necessary to convert the metric of one routing protocol into that of another routing protocol for route redistribution, since different routing protocols use different metric measurement methods. However, a symbolic metric suggest to be set for route redistribution. You can filter the routes redistributed into RIP domain using the route map. If the specified route map is not defined, all routes should be redistributed. You can use the route-map math-clauses to filter the routes, and use the route-map set-clauses to set the metric of routes redistributed into RIP domain. You can verify your settings by entering the show ip rip command. Example This example shows how to configure the redistribution of static routes to RIP. DXS-3600-32S#configure terminal DXS-3600-32S(config)#router rip DXS-3600-32S(config-router)#redistribute static DXS-3600-32S(config-router)# Example This example shows how to configure the redistribution of OSPF routes to RIP and specify the metric to 2. DXS-3600-32S#configure terminal DXS-3600-32S(config)#router rip DXS-3600-32S(config-router)#redistribute ospf metric 2 DXS-3600-32S(config-router)# Example This example shows how to configure the redistribution of OSPF routes to RIP and use the route map. DXS-3600-32S#configure terminal DXS-3600-32S(config)#route-map map1 permit 1 DXS-3600-32S(config-route-map)#match ip address list1 DXS-3600-32S(config-route-map)#set metric 4 DXS-3600-32S(config-route-map)#exit DXS-3600-32S(config)#router rip DXS-3600-32S(config-router)#redistribute ospf route-map map1 DXS-3600-32S(config-router)# Example This example shows how to configure the redistribution of static route to RIP VRF VPN-A instance. DXS-3600-32S# configure terminal DXS-3600-32S(config)# router rip DXS-3600-32S(config)# address-family ipv4 vrf VPN-A DXS-3600-32S(config-router-af)# redistribute static 52-12 router rip This command is used to enable RIP and enter the RIP router configuration mode. Use the no form of this command to disable RIP. router rip 515