D-Link DXS-3600-32S CLI Guide - Page 292

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide IP Access List Commands 26-1 ip standard access-list This command is used to enter the access list configuration mode and define a standard IP access list. Use the no form of this command to remove a standard IP access list. ip standard access-list ACCESS-LIST-NAME no ip standard access-list ACCESS-LIST-NAME Parameters ACCESS-LIST-NAME Specifies the name of the IP access-list to be configured. It can accept up to 16 characters. The syntax is general string that does not allow space. Default Command Mode Command Default Level Usage Guideline None. Global Configuration Mode. Level: 8 Standard IP access list is used by routing protocol. Users can verify the settings by entering the show ip standard access-list command. Example This example shows how to create a standard IP access list and enter the standard IP access list configuration mode. DXS-3600-32S#configure terminal DXS-3600-32S(config)#ip standard access-list IPS DXS-3600-32S(config-ip-acl)# 26-2 deny This command is used to set the deny rules of standard IP access list. Use the no form of this command to remove the deny rules. deny NETWORK-ADDRESS no deny NETWORK-ADDRESS Parameters NETWORK-ADDRESS Specifies a specific network address. Default Command Mode Command Default Level Usage Guideline None. Access List Configuration Mode. Level: 8 One or multiple deny rules can be added to the list. There is an implicit deny at the end of the statement, if you only want to deny some specified route, please add another statement which is permit 0.0.0.0 0 at the end of the ip access list, in that way there will be no negative effects on the function of access list. Users can verify the settings by entering the show ip standard access-list command. 284