D-Link DXS-3600-32S CLI Guide - Page 567

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Command Default Level Usage Guideline Level: 8 This parameter will be commonly used by STP, RSTP, and MSTP. Note: Changing this parameter to a higher value may have a significant impact on CPU utilization, especially in MSTP mode. Lowering this parameter could slow convergence in some scenarios. We recommend that you do not change the value from the default setting. Example This example shows how to configure the tx-hold-count value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#spanning-tree tx-hold-count 5 Success DXS-3600-32S(config)# 57-5 spanning-tree max-hops This command is used to configure the MSTP related max-hops timers. Use the no form of this command to return the setting to default setting. spanning-tree max-hops MAX-COUNT no spanning-tree max-hops Parameters MAX-COUNT Specifies the MSTP maximum hop number. The range is 6 to 40 hops. Default Command Mode Command Default Level Usage Guideline The default value is 20. Global Configuration Mode. Level: 8 Use this command to configure the MSTP related max-hops timers. Example This example shows how to configure the max-hops value. DXS-3600-32S#configure terminal DXS-3600-32S(config)#spanning-tree max-hops 19 Success DXS-3600-32S(config)# 57-6 spanning-tree mode This command is used to decide the STP mode. To return to the default settings, use the no form of this command. spanning-tree mode {mstp | rstp |stp} no spanning-tree mode Parameters mstp rstp stp Specifies to used the Multiple Spanning Tree Protocol (MSTP). Specifies to used the Rapid Spanning Tree Protocol (RSTP). Specifies to used the Spanning Tree Protocol (IEEE 802.1D-Compatible) 559