D-Link DXS-3600-32S CLI Guide - Page 312

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to configure port priority of Ethernet interface 1. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)#lacp port-priority 4096 DXS-3600-32S(config-if)# 31-3 lacp system-priority This command is used to set the LACP system priority. The no form of it restores it to the default. lacp system-priority system-priority no lacp system-priority Parameters system-priority Specifies the LACP system priority, in the range of 0-65535. Default Command Mode Command Default Level Usage Guideline By default, the system priority is 32768. Global Configuration Mode. Level: 15 The LACP system priority consists of the Layer 2 management MAC address and its priority value, where the MAC address is fixed but the priority value is configurable. If two priorities are equal, then the smaller the MAC address is, the higher the priority is. All LACP groups on the switch share the system priority. Changing the system priority may influence the whole aggregation groups on the switch. Example This example shows how to configure system priority. DXS-3600-32S#configure terminal DXS-3600-32S(config)#lacp system-priority 4096 DXS-3600-32S(config)# 31-4 lacp timeout This command is used to configure the LACP timeout mode. Use the no form of this command to return to the default value. lacp timeout {short | long} no lacp timeout Parameters short long Specifies that there will be 3 seconds before the LACP invalidating received LACPDU information and there will be 1 second between LACP PDU periodic transmissions when using Short Timeouts. Specifies that there will be 90 seconds before the LACP invalidating received LACPDU information and there will be 30 seconds between LACP PDU periodic transmissions when using Long Timeouts Default Command Mode Command Default Level By default, the LACP timeout mode is short. Interface Configuration Mode. Level: 15 304