D-Link DXS-3600-32S CLI Guide - Page 628

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to create a backup peer with the IP address of 2.2.2.2 and VC ID is set by VPLS ID. DXS-3600-32S#configure terminal DXS-3600-32S(config)#vpls vpls100 DXS-3600-32S(config-vpls)#peer backup 2.2.2.2 DXS-3600-32S(config-vpls)# Example This example shows how to create a backup peer with the IP address of 2.2.2.2 and VC ID of 100. DXS-3600-32S#configure terminal DXS-3600-32S(config)#vpls vpls100 DXS-3600-32S(config-vpls)#peer backup 2.2.2.2 100 DXS-3600-32S(config-vpls)# 67-7 xconnect vpls This command is used to create a local AC in a VPLS. Use the no xconnect vpls command to delete a local AC in a VPLS. xconnect vpls VPLS-NAME no xconnect vpls VPLS-NAME Parameters VPLS-NAME Specifies the VPLS name. This name can be up to 32 characters long. Default Command Mode Command Default Level Usage Guideline None. Interface Configuration Mode (Ethernet Interface or Ethernet VLAN Interface Mode). Level: 15. This command is used to create a local AC in a VPLS. A local AC could be an Ethernet-based AC, which is created in an Ethernet interface, or an Ethernet VLANbased AC, which is created in Ethernet VLAN interface. All local ACs in a VPLS should have same AC type. Example This example shows how to create a local AC, which is an Ethernet-based AC and the Ethernet port is 1/0/1, into a VPLS with the name of vpls100. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface GigabitEthernet 1/0/1 DXS-3600-32S(config-if)#xconnect vpls vpls100 DXS-3600-32S(config-if)# Example This example shows how to create a local AC, which is an Ethernet VLAN-based AC, the Ethernet port is 1/0/1, and the VLAN is 100, into a VPLS with the name of vpls100. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface GigabitEthernet 1/0/1 DXS-3600-32S(config)#encapsulation dot1q 100 DXS-3600-32S(config-subif)#xconnect vpls vpls100 DXS-3600-32S(config-subif)# 620