D-Link DXS-3600-32S CLI Guide - Page 309

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide LINE Commands 30-1 line This command is used to enter the specified LINE mode. The no form of this command is used to restore the default configuration. line {console | telnet | ssh} no line {console | telnet | ssh} Parameters console telnet ssh Specifies the console port. Specifies the Telnet terminal line. Specifies the SSH terminal line. Default Command Mode Command Default Level Usage Guideline None. Global Configuration Mode. Level: 15 Access to the specified LINE mode. Example This example shows how to enter the LINE mode from LINE CONSOLE. DXS-3600-32S#configure terminal DXS-3600-32S(config)#line console DXS-3600-32S(config-line)# 30-2 exec-timeout This command is used to configure the connection timeout to this equipment in the LINE, use the exec-timeout command. Once the connection timeout in the LINE is cancelled by the no exec-timeout command, the connection will never be timeout. exec-timeout minutes [seconds] no exec-timeout Parameters minutes seconds Specifies the minutes of specified timeout. This value must be between 0 and 1439. (Optional) Specifies the seconds of specified timeout. Default Command Mode Command Default Level Usage Guideline The default timeout is 10min. Line Configuration Mode. Level: 15 If there is no input/output information for this connection within specified time, this connection will be interrupted, and this LINE will be restored to the free status. Example This example shows how to specify the connection timeout is 5'30". DXS-3600-32S#configure terminal DXS-3600-32S(config)#line console DXS-3600-32S(config-line)#exec-timeout 5 30 DXS-3600-32S(config-line)# 301