D-Link DXS-3600-32S CLI Guide - Page 501

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to display the QCN CNPV settings. DXS-3600-32S#show qcn cnpv Dot1p Defense Admin Defense Alternate CP Priority Mode Choice Mode Priority Creation 1 admin interior 0 enable 2 auto interior-ready 0 disable DXS-3600-32S# Example This example shows how to display the total discarded frames, auto alternate priority and error portlist for all CNPVs. DXS-3600-32S#show qcn cnpv status QCN Status : Enabled QCN Discarded Frames : 1234 CNM Transmit Priority : 1 CNPV: 1 Auto Alternate Priority : 0 Errored Portlist : --- CNPV: 2 Auto Alternate Priority : 0 Errored Portlist : --- !---Output Truncated. DXS-3600-32S# 49-8 show qcn cnpv interface This command is used to display the QCN configuration and status for each Congestion Notification Priority Value (CNPV). show qcn cnpv PRIORIT-VALUE [, | -] interface [INTERFACE-ID [, | -]] [simple] Parameters PRIORIT-VALUE [, | -] INTERFACE-ID [, | -] simple Specifies the priority value to display in the configuration and status. The valid priority value range is 0 to 7. You can specify multiple priority values, which are separated by "," or "-". (Optional) Specifies the interface to display QCN CNPV information. Valid interfaces are physical interfaces. You can specify multiple interfaces, which are separated by "," or "-". Otherwise, display the CNPV configuration and status for all physical interfaces. (Optional) Specifies to only display the CND defense mode which would operate for the CNPV as determined by the LLDP Congestion Notification TLV. Default Command Mode Command Default Level Usage Guideline None. EXEC Mode. Level: 3. Use this command to display the QCN per priority or interface configuration and the status. Use this command with the simple option to display the CND defense mode controlled by the LLDP Congestion Notification TLV. 493