D-Link DXS-3600-32S CLI Guide - Page 229

Usage Guideline DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide For each source network reported, a route metric is associated with the route being reported. The metric is the sum of the interface metrics between the router originating the report and the source network. For the purposes of DVMRP, the Infinity metric is defined to be 32. This limits the breadth across the whole DVMRP network and is necessary to place an upper bound on the convergence time of the protocol. To verify you configuration, use the show ip dvmrp interface command. Example This example shows how to configure the DVMRP metric of VLAN 1 to 30. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 1 XS-3600-32S(config-if)#ip dvmrp metric 30 DXS-3600-32S(config-if)# Example This example shows how to configure the DVMRP metric of VLAN 2 back to default. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface vlan 2 XS-3600-32S(config-if)#no ip dvmrp metric DXS-3600-32S(config-if)# 15-3 show ip dvmrp interface This command is used to display DVMRP interface information. show ip dvmrp interface [IFNAME] Parameters IFNAME Specifies the interface name. Default Command Mode Command Default Level Usage Guideline None. Privileged EXEC Mode. Level: 3. (EI Mode Only Command) This command is used to display basic DVMRP interface information. If no interface name is specified, the command will list all interfaces' info. Example This example shows how to show all DVMRP interfaces information. DXS-3600-32S#show ip dvmrp interface Interface -----------vlan1 vlan2 IP Address 10.90.90.90 90.1.1.1 Metric -----1 1 Generation ID 1368947491 0 State -------Enabled Disabled DXS-3600-32S# Example This example shows how to show information of interface 'vlan1'. DXS-3600-32S#show ip dvmrp interface vlan1 Interface IP Address Metric Generation ID State vlan1 10.90.90.90 1 1368947491 Enabled DXS-3600-32S# 221