D-Link DXS-3600-32S CLI Guide - Page 380

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide all Specifies to remove all MPLS QoS policies. Default Command Mode Command Default Level Usage Guideline No MPLS QoS policy. Global Configuration Mode. Level: 8. Use this command to enter the MPLS QoS configuration mode. If the policy doesn't exist, a new policy will be created. The MPLS QoS policy can be applied to MPLS FECs. Example This example shows how to create an MPLS QoS policy with the name of policy1. DXS-3600-32S#configure terminal DXS-3600-32S(config)#mpls qos policy policy1 DXS-3600-32S(config-mpls-qos)# 38-45 trust-exp This command is used to configure to trust the incoming label's topmost EXP as priority. Use the no trust-exp command to disable the trust. trust-exp no trust-exp Parameters Default Command Mode Command Default Level Usage Guideline None. Disabled. MPLS QoS Configuration Mode. Level: 15. Use this command, in the MPLS QoS configuration mode, to configure to trust the incoming label's topmost EXP as priority. If the EXP is set to trust, the matched packets are scheduled according to the EXP to priority map the MPLS QoS policy. Otherwise, the packets are scheduled according to the 802.1p priority. Example This example shows how to enable EXP trust. DXS-3600-32S#configure terminal DXS-3600-32S#(config)#mpls qos policy policy1 DXS-3600-32S#(config-mpls-qos)#trust-exp DXS-3600-32S#(config-mpls-qos)# 38-46 class-map This command is used to configure class mapping of the policy. Use the no class-map command to remove the setting. class-map {inbound exp priority | outbound [priority ] exp } no class-map {inbound | outbound} Parameters exp Specifies the EXP or EXP range. priority Specifies the priority of the inbound EXP mapped. priority (Optional) Specifies the priorities that will be mapped to the outbound EXP. If not specifies, then all priorities will be mapped. exp Specifies the outbound EXP. 372