D-Link DXS-3600-32S CLI Guide - Page 598

Usage Guideline DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide The memory buffer for the log is used in a recycled manner. That is, when it is full, the oldest information will be overwritten. The content of the logging buffer will be saved to the FLASH periodically if the interval time is specified, so the message can be restored on reboot. To show the log information in the memory buffer, run show logging at the privileged user level. As lower values indicate higher levels, level 0 indicates the information of the highest level. When the level of log information to be displayed on a specified device, the log information is at or below the set level will not be displayed. Example This example shows how to disable record logs into flash. DXS-3600-32S#configure terminal DXS-3600-32S(config)#logging buffered write-delay infinite DXS-3600-32S(config)# 60-12 save log This command is used to save the log. save log Parameters Default Command Mode Command Default Level Usage Guideline None. None. Global Configuration Mode. Level: 15 As log entries are created and store in the DRAM, a log message may be lost while powering down the switch. To avoid the loss of log entries, the administrator needs save the log into the NVRAM via UI or use the periodical save command to save the log to the NVRAM. Example This example shows the command of save log. DXS-3600-32S#configure terminal DXS-3600-32S(config)#save log Saving all system logs to NV-RAM Done. DXS-3600-32S(config)# 1 2011-12-23 17:35:27 INFO(6) System log saved to flash by console (Username : Anonymous) DXS-3600-32S(config)# 590